Model TA Conveyor Belt Misalignment System

• Keeps damage costs due to belt mis-alignment low by ensuring properly aligned belt.
• Highly visible red epoxy coated roller of 1-1/4” diameter with nylon bushings.
• Cast aluminum housing and optional cast iron housings available.
• Allows for shut down along entire belt length.
• Simple Installation – drill (3) 13/32″ diameter holes and mount on a conveyor 
• 3/4″ NPT conduit opening
• Roller arm can move up to 90 degrees in either direction and is spring loaded for automatic reset
• Optional manual reset available
• Operating temperature range: -40° F to 150° F

RTD / RTD-LT RTD Temperature Sensors with RTD Output, with and without Liquid-Tight Conduit Fittings

• 3-wire Platinum Pt100 RTD output
• Attachment probe, sensor and cable
• Compatible with PLCs, meters, data acquisition, and hazard monitoring system with 3-wire Pt100 RTD- inputs
• Integral 1/2 in. flexible liquid-tight conduit fittings (RTDZ/S-LT models)
• Intrinsically Safe (IS) Class I, Div I (A, B, C, D),
• Class II, Div I (E, F, G) I.S. Simple Apparatus
• Models:

RTDZ – 1/4 in. stainless steel probe
 RTDS – 3/8-16 threaded stud probe
RTDZ-LT – RTDZ with a 1/8 NPT adapter and 1/2 in. flexible liquid-tight conduit fitting (e.g. grease fitting for bearing temperature)
RTDS-LT – RTDS with a 1/2 in. flexible liquid-tight conduit fitting (e.g. belt alignment rub block temperature)

TT420-LT Temperature Sensors with 4-20 mA Output and Liquid-Tight Conduit Fittings

2-wire, loop-powered 4-20 mA analog output

• Attachment probe, sensor, 2-wire 4-20 mA signal conditioner and conduit fitting in one
• No user calibration: works right out of the box
• Compatible with PLCs, meters, data acquisition, and hazard monitoring systems
• Reverse-wiring protected
• Integral 1/2 in flexible liquid-tight conduit fittings
• Optimized for Class II area hazard monitor systems (e.g. grain, coal dust)
• FM approved, Dust Ignition-proof. Class II and III, Div I (E, F, G); NEMA 4
• 2 model families for temperature monitoring

TT420S-LT* – 3/8 – 16 threaded stud probe (e.g. belt-alignment rub block temperature)
TT420Z-LT* – 1/4 in stainless steel probe with 1/8 NPT adapter (e.g. zerk grease fitting for bearing temperature)

TT420 Temperature Sensors with 4-20 mA Output

• 2-wire, loop-powered 4-20 mA analog output
• Attachment probe, sensor, and 2-wire 4-20 mA signal conditioner in one
• No user calibration: works right out of the box
• Compatible with PLCs, meters, and data acquisition systems
• Reverse-wiring protected
• UL listed, Intrinsically Safe (IS) Class I, Div I (C, D) and Class II, Div I (E, F, G)
• 3 Models for Industrial Temperature Monitoring
• TT420F – flat surface mount- mounts onto any flat surface with a #10 machine screw (included)
• TT420S – 1/4-28 threaded stud- screws into any 1/4-28 tap
• TT420Z* – 1/4 in stainless steel probe – often used with compression fitting mount (tanks, piping, bearing zerk grease fittings)